Managing container swap memory space on Amazon ECS - Amazon Elastic Container Service
Considerations

Managing container swap memory space on Amazon ECS

With Amazon ECS, you can control the usage of swap memory space on your Linux-based Amazon EC2 instances at the container level. Using a per-container swap configuration, each container within a task definition can have swap enabled or disabled. For those that have it enabled, the maximum amount of swap space that's used can be limited. For example, latency-critical containers can have swap disabled. In contrast, containers with high transient memory demands can have swap turned on to reduce the chances of out-of-memory errors when the container is under load.

The swap configuration for a container is managed by the following container definition parameters.

maxSwap

The total amount of swap memory (in MiB) a container can use. This parameter is translated to the --memory-swap option to docker run where the value is the sum of the container memory plus the maxSwap value.

If a maxSwap value of 0 is specified, the container doesn't use swap. Accepted values are 0 or any positive integer. If the maxSwap parameter is omitted, the container uses the swap configuration for the container instance that it's running on. A maxSwap value must be set for the swappiness parameter to be used.

swappiness

You can use this to tune a container's memory swappiness behavior. A swappiness value of 0 causes swapping to not occur unless required. A swappiness value of 100 causes pages to be swapped aggressively. Accepted values are whole numbers between 0 and 100. If the swappiness parameter isn't specified, a default value of 60 is used. If a value isn't specified for maxSwap, this parameter is ignored. This parameter maps to the --memory-swappiness option to docker run.

In the following example, the JSON syntax is provided.

"containerDefinitions": [{
        ...
        "linuxParameters": {
            "maxSwap": integer,
            "swappiness": integer
        },
        ...
}]

Considerations

Consider the following when you use a per-container swap configuration.

  • Swap space must be enabled and allocated on the Amazon EC2 instance hosting your tasks for the containers to use. By default, the Amazon ECS optimized AMIs do not have swap enabled. You must enable swap on the instance to use this feature. For more information, see Instance Store Swap Volumes in the Amazon EC2 User Guide or How do I allocate memory to work as swap space in an Amazon EC2 instance?.

  • The swap space container definition parameters are only supported for task definitions that specify the EC2 launch type. These parameters are not supported for task definitions intended only for Amazon ECS on Fargate use.

  • This feature is only supported for Linux containers. Windows containers are not supported currently.

  • If the maxSwap and swappiness container definition parameters are omitted from a task definition, each container has a default swappiness value of 60. Moreover, the total swap usage is limited to two times the memory of the container.

  • If you're using tasks on Amazon Linux 2023 the swappiness parameter isn't supported.