Configuring health checks for your service - AWS App Runner
Configure health checks

Configuring health checks for your service

AWS App Runner monitors the health of your service by performing health checks. The default health check protocol is TCP. App Runner pings the domain assigned to your service. You can alternatively set the health check protocol to HTTP. App Runner sends health check HTTP requests to your web application.

You can configure a few settings related to health checks. The following table describes the health check settings and their default values.

Setting Description Default

Protocol

The IP protocol that App Runner uses to perform health checks for your service.

If you set the protocol to TCP, App Runner pings the default domain assigned to your service at the port that your application is listening to.

If you set the protocol to HTTP, App Runner sends health check requests to the configured path.

TCP

Path

The URL that App Runner sends HTTP health check requests to. Applicable only to HTTP checks.

/

Interval

The time interval, in seconds, between health checks.

5

Timeout

The time, in seconds, to wait for a health check response before deciding it failed.

2

Healthy threshold

The number of consecutive checks that must succeed before App Runner decides that the service is healthy.

1

Unhealthy threshold

The number of consecutive checks that must fail before App Runner decides that the service is unhealthy.

5

Configure health checks

Configure health checks for your App Runner service using one of the following methods:

App Runner console

When you create your App Runner service using the App Runner console, or when you update its configuration later, you can configure health check settings. For full console procedures, see Creating an App Runner service and Configuring an App Runner service. In both cases, look for the Health check configuration section on the console page.

App Runner console configuration page showing health check options
App Runner API or AWS CLI

When you call the CreateService or UpdateService API actions, you can use the HealthCheckConfiguration parameter to specify health check settings.

For information about the parameter's structure, see HealthCheckConfiguration in the AWS App Runner API Reference.