# Enable Internet Access for Your Fleet, Image Builder, or App Block Builder in Amazon WorkSpaces Applications
<a name="managing-network-manual-enable-internet-access"></a>

After your NAT gateway is available on a VPC, you can enable internet access for your fleet, image builder, and app block builder.

**Note**  
When working with IPv6 only subnets, default internet access cannot be enabled. You'll need to set up an Egress-Only Internet Gateway and configure route table to allow outbound internet traffic. For more information check the [steps](https://docs.aws.amazon.com/vpc/latest/userguide/egress-only-internet-gateway.html). You also need to enable auto-assign IPv6 addresses for your subnets. The Egress-Only gateway handles outbound internet traffic only so if you need inbound access, you'll still need a regular internet gateway. You can find more details about this in [egress only internet gateway documentation](https://docs.aws.amazon.com/vpc/latest/userguide/egress-only-internet-gateway.html). Ensure appropriate security and networking controls exist to prevent accidental inbound/outbound access for your subnets.

**Topics**
+ [Enable Internet Access for Your Fleet in Amazon WorkSpaces Applications](managing-network-manual-fleet-enable-internet-access-fleet.md)
+ [Enable Internet Access for Your Image Builder in Amazon WorkSpaces Applications](managing-network-manual-enable-internet-access-image-builder.md)
+ [Enable Internet Access for Your App Block Builder in Amazon WorkSpaces Applications](managing-network-enable-internet-access-app-block-builder.md)