Initialize instance store volumes on EC2 instances
Because of the way that Amazon EC2 virtualizes disks, the first write to any location on some instance store volumes performs more slowly than subsequent writes. For most applications, amortizing this cost over the lifetime of the instance is acceptable. However, if you require high disk performance, we recommend that you initialize your drives by writing once to every drive location before production use.
Note
Instance types with direct-attached solid state drives (SSD) and TRIM support provide maximum performance at launch time, without initialization. For information about the instance store for each instance type, see Instance store volume limits for EC2 instances.
If you require greater flexibility in latency or throughput, we recommend using Amazon EBS.
To initialize the instance store volumes, use the following dd commands,
depending on the store to initialize (for example, /dev/sdb or
/dev/nvme1n1).
Note
Make sure to unmount the drive before performing this command.
Initialization can take a long time (about 8 hours for an extra large instance).
To initialize the instance store volumes, use the following commands on the
m1.large, m1.xlarge, c1.xlarge,
m2.xlarge, m2.2xlarge, and m2.4xlarge instance
types:
dd if=/dev/zero of=/dev/sdb bs=1M dd if=/dev/zero of=/dev/sdc bs=1M dd if=/dev/zero of=/dev/sdd bs=1M dd if=/dev/zero of=/dev/sde bs=1M
To perform initialization on all instance store volumes at the same time, use the following command:
dd if=/dev/zero bs=1M|tee /dev/sdb|tee /dev/sdc|tee /dev/sde > /dev/sdd
Configuring drives for RAID initializes them by writing to every drive location. When configuring software-based RAID, make sure to change the minimum reconstruction speed:
echo $((30*1024)) > /proc/sys/dev/raid/speed_limit_min
