GetReadSet
Gets a file from a read set.
Request Syntax
GET /sequencestore/sequenceStoreId/readset/id?file=file&partNumber=partNumber HTTP/1.1
URI Request Parameters
The request uses the following URI parameters.
- file
-
The file to retrieve.
Valid Values:
SOURCE1 | SOURCE2 | INDEX - id
-
The read set's ID.
Length Constraints: Minimum length of 10. Maximum length of 36.
Pattern:
[0-9]+Required: Yes
- partNumber
-
The part number to retrieve.
Valid Range: Minimum value of 1. Maximum value of 10000.
Required: Yes
- sequenceStoreId
-
The read set's sequence store ID.
Length Constraints: Minimum length of 10. Maximum length of 36.
Pattern:
[0-9]+Required: Yes
Request Body
The request does not have a request body.
Response Syntax
HTTP/1.1 200
payloadResponse Elements
If the action is successful, the service sends back an HTTP 200 response.
The response returns the following as the HTTP body.
- payload
-
The read set file payload.
Errors
For information about the errors that are common to all actions, see Common Errors.
- AccessDeniedException
-
You do not have sufficient access to perform this action.
HTTP Status Code: 403
- ConflictException
-
The request cannot be applied to the target resource in its current state.
HTTP Status Code: 409
- InternalServerException
-
An unexpected error occurred. Try the request again.
HTTP Status Code: 500
- RangeNotSatisfiableException
-
The ranges specified in the request are not valid.
HTTP Status Code: 416
- RequestTimeoutException
-
The request timed out.
HTTP Status Code: 408
- ResourceNotFoundException
-
The target resource was not found in the current Region.
HTTP Status Code: 404
- ThrottlingException
-
The request was denied due to request throttling.
HTTP Status Code: 429
- ValidationException
-
The input fails to satisfy the constraints specified by an AWS service.
HTTP Status Code: 400
See Also
For more information about using this API in one of the language-specific AWS SDKs, see the following:
