Setting up your Storage Gateway Hardware Appliance - AWS Storage Gateway

Setting up your Storage Gateway Hardware Appliance

After you receive your Storage Gateway Hardware Appliance, you use the hardware appliance local console to configure networking to provide an always-on connection to AWS and activate your appliance. Activation associates your appliance with the AWS account that is used during the activation process. After the appliance is activated, you can launch an S3 File Gateway, FSx File Gateway, Tape Gateway, or Volume Gateway from the Storage Gateway console.

To install and configure your hardware appliance

  1. Rack-mount the appliance, and plug in power and network connections. For more information, see Physically installing your hardware appliance.

  2. Set the Internet Protocol version 4 (IPv4) addresses for the hardware appliance (the host). For more information, see Configuring hardware appliance network parameters.

  3. Activate the hardware appliance on the console Hardware appliance overview page in the AWS Region of your choice. For more information, see Activating your Storage Gateway Hardware Appliance.

  4. Create a gateway on your hardware appliance. For more information, see Creating a Volume Gateway.

    You set up gateways on your hardware appliance the same way that you set up gateways on VMware ESXi, Microsoft Hyper-V, Linux Kernel-based Virtual Machine (KVM), or Amazon EC2.

Increasing the usable cache storage

You can increase the usable storage on the hardware appliance from 5 TB to 12 TB. Doing this provides a larger cache for low latency access to data in AWS. If you ordered the 5 TB model, you can increase the usable storage to 12 TB by buying five 1.92 TB SSDs (solid state drives).

You can then add them to the hardware appliance before you activate it. If you have already activated the hardware appliance and want to increase the usable storage on the appliance to 12 TB, do the following:

  1. Reset the hardware appliance to its factory settings. Contact AWS Support for instructions on how to do this.

  2. Add five 1.92 TB SSDs to the appliance.

Network interface card options

Depending on the model of appliance you ordered, it may come with a 10G-Base-T RJ45 copper, 10G DA/SFP+, or 25G DA/SFP28 network card.

  • 10G-Base-T NIC configuration:

    • Use CAT6 cables for 10G or CAT5(e) for 1G

  • 10G DA/SFP+ NIC configuration:

    • Use Twinax copper Direct Attach Cables up to 5 meters

    • Dell/Intel compatible SFP+ optical modules (SR or LR)

    • SFP/SFP+ copper transceiver for 1G-Base-T or 10G-Base-T

  • 25G DA/SFP28 NIC configuration:

    • Use Twinax copper Direct Attach Cables up to 5 meters

    • 25G or 10G optical modules (SR or LR)

    • SFP+ copper transceiver for 10G-Base-T