You must deploy the Link device into the AWS cloud.
Note
You don't need to be logged into any AWS service to set up the Link device.
Deploying the hardware
-
To set up the device and the camera that provides the source content, and to connect the device to the internet, see the instructions included in the packaging.
When you connect the device to the internet, it will verify connectivity by contacting the following domains. If you are watching network traffic, you might see outbound traffic to these domains:
-
amazon.com
-
aws.amazon.com
-
-
After you have connected the device to the internet, the device automatically connects to MediaLive in the AWS account and the AWS Region that it is configured for.
A user with AWS permissions can view the device on the console, and transfer the device to a different Region.
Performing network diagnostics
If you have problems connecting the device to the internet, you can use the diagnostics utility to troubleshoot these problems.
-
Use the instructions in your Link packaging to connect to the device's on-board user interface.
-
Locate the navigation pane on the left-hand side.
-
Select Network Diagnostics, then select Run diagnostics test at the top of the page.
The network diagnostic test starts and takes a few seconds to run.
-
The Test Information page appears. This page displays network information and displays the test results: pass or fail (with a reason, and possibly with troubleshooting steps).
The diagnostics feature tests the following:
-
IP address valid – The configured IP address was successfully applied to the device.
-
Gateway responsive – There is a connection between the device and the gateway.
-
DNS resolution – The hostnames resolve to each of the configured DNS servers.
-
AWS connectivity – There is a connection between the device and AWS over HTTPS.
-
Time server connectivity – The device can sync the internal time clock using NTP on port 123.
-
Stream connectivity – The device can send video packets to AWS using port 2088.
